Guide Codes
- Thread starter GWL
- Start date
Good to know. Do you mind sharing what code you had and how it was repaired?
- Thread starter
- #3
Mine was giving me 1214 & 1217 & No Comm. Also showing the three dash lights for ABS, Traction Control & (forgot the third!)
I removed the module and sent to ABSFIXER, they turn around in one day, so 1 week down and 1 week back. They resolder as required and replace the relay if required. I also had them install surge suppression while they had it apart.
Thanks for that. Looks like a good resource to know about and have confidence with it.
Hotrodron
Regular
You're 5
C5
USA
You're a Regular
You're Celebrated
You're Liked
Completionist Award
I watched an episode of Wheeler Dealers on Motortrend & they were flipping a 2002 Z06.They were getting the ABS codes(Don't remember which code) & they pulled the module & brought it to a vette shop & they showed how they repair the unit.All they did was, open up the module (6 screws) un-soldered a relay & put in a new one ( $10.00 ) & re-soldered it.The kid that was doing the repair made it look easy
- Thread starter
- #7
You are correct. I saw that also. It is not the actual soldering/repair that intimidates, it's getting that darn module apart without breaking something. I tried for a half hour and decided I better send it out before I broke it and had to buy another one!
They made it look too easy. The way they diagnosed the relay issue left me wondering (how without a schematic of the circuit you can just use a meter to determine what part is faulty). What if it was something other than the relay, for example. They were lucky to know of a local shop that was familiar with the circuit and had parts on hand. I also noted that they were not charged any labor to diagnose and fix the problem so that is why the cost was only $10 (just the part itself likely).
Last edited:
- Thread starter
- #9
Yes, we have to remind ourselves that it was a TV show, with limited time to show the complete situation. The later C5's are notorious for cold solder joints in the EBCM and the relay is simply used to turn power on/off. If the relay contacts are confirmed with a ohmmeter to have a resistance higher than expected, it's simple to replace at that point...or for peace of mind! In most instances, just desoldering/resoldering the 5 relay pins fixes the problem. In my instance, the issues would appear after a long run and heat soak which indicated to me the cold solder intermittent points (No Comm). I was fortunate that fixed my issues. In another instance it may take a electronics technician to find an intermittent part elsewhere...but at what cost. May be cheaper to buy a reconditioned module...?? The US Forum has a tremendous documentation on the subject with detailed instructions on how to do the repair yourself.
Last edited:
Hotrodron
Regular
You're 5
C5
USA
You're a Regular
You're Celebrated
You're Liked
Completionist Award
