Cell Phone Holder

[D Dunn]

Anyone found a cel phone holder that works for a C 5?
I don’t want to mount it on the windshield or dash
I thought the Weather tech product that fits in the cup holder would work, too shallow

 

[Gummiente]

I just bought these off Amazon for my BlackBerry KeyOne, they're smaller than they look but work quite well. I mounted one to the cupholder lid (no drinks allowed in my car!) and angled the phone to slot neatly between the shifter and emerg brake..

2 Pack Magnetic Phone Holder

 

[D Dunn]

I just bought these off Amazon for my BlackBerry KeyOne, they're smaller than they look but work quite well. I mounted one to the cupholder lid (no drinks allowed in my car!) and angled the phone to slot neatly between the shifter and emerg brake..

2 Pack Magnetic Phone Holder

Thanks, I should have mentioned my car is standard
Would this unit with the phone in place allow enough space for shifting?

 

[Gummiente]

Possibly. The height of the mount is about 1.5", so it all depends on the length and width of your phone. Apologies for the crappy pic quality, but I had to take it with my tablet...

 

[D Dunn]

Thanks for the pic
I think it will interfere with the shifter

 

[Vanguard2001]

Check out Pro Clip. They have mounts and holders for just about any car and phone. I have used them in my last 6 vehicles including my 2019 GC coupe. A bit pricy but top notch quality and fit.

 

[Howard Purchase]

I use a magnetic mount that attaches to the vents in the middle of the dash. Works great.

Amazon product ASIN B0109JIQ0W

 

[theboss]

I have a dual cup holder travel buddy o with th oem cup holder, passenger nd driverhave a place for a drink and one left for the phone. No drilling just squeze i in place.

 

[fak]

My C5 is standard. Getting into reverse is no problem.

Scosche is the brand.

Amazon.ca has them.

 

[D Dunn]

My C5 is standard. Getting into reverse is no problem.

Scosche is the brand.

Amazon.ca has them.

Looks good!
How’s it held in place in the cup holder? Suction cup? Magnet?
Which model do you have?
Appreciate your help!

 

[fak]

Suction cup.
I glued a flat, round piece of plastic to the bottom of the cup holder to create a flat surface.
This a link to the model. I assume you were asking about the model of the cell phone holder vs the C5 model.

The suction sometime lets go and needs to be reset but overall it's a pretty good solution.

 

[D Dunn]

Suction cup.
I glued a flat, round piece of plastic to the bottom of the cup holder to create a flat surface.
This a link to the model. I assume you were asking about the model of the cell phone holder vs the C5 model.

The suction sometime lets go and needs to be reset but overall it's a pretty good solution.

Thanks, looks like you found a great solution!
Good idea to remove the lid for the cup holder
I’ll give it a try!
Thanks again for sharing!

 

[fak]

Glad to help.