Recent content by Jr. Corvette

I had a chance to go under my car today and did some measuring. My rims are inset so I couldn't measure to them but I measured to my dust shields. The dust shields to the center of the tie rod ends measures 2" on both sides. My guess if you have one side that is closer to the rim, the steering...

Hey Tom. I see it's been a while since you posted this. I have to adjust my front coil overs sometime so I will have a look at the tie rods and let you know. Cody

Hey guys, It's been a while. I've been making lots of new parts but due to the restrictions of the forum I am not allowed to talk about my new company or the many parts I now make. That is extremely disappointing as I have been an active member on here for over 10 years and have provided lots...

Hey George. One thing I found that works incredibly well is brush or roll on POR15 and then hit it with zero rust black aerosol after and hour or two. I tested this vs just POR15 and just zero rust and this holds up to hammer strikes. Makes a super smooth satin/flat black finish that almost...

Thanks @1 BAD 9T9! Really appreciate the kind words.

Website is now up! Coderedcustomdesigns.ca