Recent content by 69C3

I just checked the C.C site and didn't notice the 4 piece deal you had mentioned. Would you mind forwarding me the # please. Thanx Chuck

Do you know what the bore sizes are for both the "Lip Style" and "O-Ring"? I'm not certain which style I currently have on the car.

Thanks Graham, I've heard not so great opinions regarding the "Lip Seal" design and will be considering the purchase of the "O-Ring" design within a month or so. Thank you for your time. Chuck

How does one determine the difference between a Lip Seal vs. O-Ring caliper. The car in question is a 1969 c3. Thank you

I have a 69c3...350/350. I cannot make out the existing (or lack there of) engine I.D numbers that were/are stamped in the traditional location on the engine. It appears as though previous owners have sanded the surface dare near clean. QUESTION...is there another location I should be...

Evening All, Re: 1969 C3, 350c.i/350hp At some point in it's life the stock distributor has been replaced with an H.E.I unit, in doing so the Tach. drive has been disconnected. To my knowledge (and I could be mistaken) in order to get the existing Tach. to function I have but two choices...

Thank you. I have power at the wiper switch and the audible clicking noise that appears to be coming from under the dash area as previously mentioned. However, I am not getting power at the actual plug at the wiper motor itself. I am reluctant to remove the upper console (where the guages are...

Re: 1969 C3 When turning on the wipers with the key in the "start" position....nothing happens. There is an audible click coming from somewhere under the dash...perhaps a relay...donno. Any advice or recommendations would be appreciated. Thanks

Thanks Doug, I appreciate it. I'm currently waiting for my manual to arrive...ordered it from Manny at DaSilva's

Any advice would be appreciated regarding the proper removal of the wiper arms. It is a fairly confined work area and I'm not wanting to damage anything through ignorance. Cheers

Thank you Yes, I've spoken to Manny....seems to be the place. Thanks again.

Looking for a good knowledgeable Corvette mechanic or shop in the Oshawa area. Any references would be appreciated. Thanks

Thanks guys, however, the trim tag is longer present. I will try the phone # noted on the GM Vintage Vehicle site. Thanks again, Chuck

Regarding NCRS documentation, do I contact the Provincial chapter or NCRS at a national level? Also, how do I determine if my 1969c3 is an early or late production. Apparently, this info. may be needed when ordering certain and specific parts. Thanks Chuck

Is there a trick to removing the horn button on a 1969 with the original steering wheel? Thanks folks. Chuck